The Special Hobby 1/32 Curtiss P-36A
Click on the thumbnail to go to a full size image.

The aft cockpit bulkhead also need some trimming on the sides to allow the fuselage to come together without gaps.  Once that was done,
the front bulkhead, floor, and rear bulkhead were set in place, tape holding the floor at the right height, and the bulkheads were glued to the
right fuselage assembly.  The floor was then glued to the bulkheads on the bottom.  A part has been attached to the back of the
aft bulkhead before installation, it has details visible through a large opening in the aft bulkhead.