All the resin parts and a few others. The resin parts in the center are the overturn structure. It came off the bottom pour block with a fine JLC saw with no trouble. Because the seat belts were
molded nicely I painted the belts first and then used multiple thin coats of interior green and flowed the paint on the seats from a soft long round point brush. Seemed to work well,
capillary action brought the paint up to the belt detail nicely. Near as I can tell the little device in the front of the cowl is a relief tube venturi. My subject did not have this,
and it's the first time I've seen it in a model kit. Above the cowl are the flap hinges. I got them off of the pour stub OK as they are held by a wafer thin connection but the first one
I tried to clean up blasted off from the tweezers so I made flap hinges from plastic card.