High Quality Plan Sets and Laser Cut Partial Kits for Radio Control
Aircraft
Page 5
Henry Struck's 1937 Benny Boxcar in 108 inch span
The front fin post extends down through a
hole cut in the tailwheel support. This hole is not laser cut as it
is unlikely that the fin post will fit in a precut hole, so it must be
located by trial fitting of the fin assembly to the fuselage.
Laying out the location of the 3/16 carbon
fiber elevator joiner on the back of the elevator spars.
Routing in a recess for the carbon fiber joiner. The parts are clamped
to an aluminum angle which also provides a guide for the Dremel tool.
A dam was made with clay before using 30
minute epoxy to install the joiner.
